In fact, learning to drive a car is to learn how to clutch. It ’s important to learn to step on and off the clutch. If you do n’t step on the clutch well, it ’s easy to hurt the car. In severe cases, even the clutch pressure plate and flywheel end face are ablated and injured, which causes the clutch compression spring to anneal and other failures. At the same time, it will also lead to fuel and car expenses, and increase driving costs. When starting, slowly loosening the clutch makes the body start to move. At this moment, it is similar to riding a bicycle first to make the car move from stationary to moving. Once you move, you do n’t need to leave the pedal so much. After that, the left foot should slowly step down a little bit more slowly. How slow? How much do you step on? You need to figure it out according to different cars in the process of learning. The operating method of clutch stepping when starting is one fast, two slow and three linkages. That is, the pedal is raised quickly at the beginning of the pedal lift; when the clutch is semi-linked, the pedal is lifted at a slower speed; from the linkage to the full engagement, the pedal is slowly lifted. When the clutch pedal is raised, gradually press the accelerator pedal according to the resistance of the engine, so that the car starts smoothly. When shifting gears while driving, the pedal of the electromagnetic clutch should be quickly depressed and lifted, so as not to cause semi-interaction, otherwise, it will accelerate the wear of the clutch. In addition, pay attention to cooperate with the throttle when operating. In order to smooth the shift and reduce the wear of the transmission shift mechanism and clutch, the two-clutch clutch shift method is advocated. Although this method is more complicated to operate, it is a good way to save money by driving. In the driving of the car, except to stop the clutch pedal when braking at a low speed, do not try to depress the clutch pedal in other situations. In low-speed driving, the braking and stopping method is to press the brake pedal first and then the clutch pedal to stop the car smoothly.